| version 1.2, 2002/04/04 17:10:58 |
version 1.3, 2002/04/06 01:38:52 |
|
|
| # Doxyfile 1.2.13.1 |
# Doxyfile 1.2.13.1 |
| |
|
| |
|
| # RAJO: |
|
| # - potrebujem, aby sa Doxyfile generoval z Doxyfile.in |
|
| # - Doxyfile.in bude obsahovat take haluzne @NAME@ @VERSION@ a podobne |
|
| # - ked sa spusti ./configure tak sa vygeneruje Doxyfile z Doxyfile.in |
|
| |
|
| |
|
| # This file describes the settings to be used by the documentation system |
# This file describes the settings to be used by the documentation system |
| # doxygen (www.doxygen.org) for a project |
# doxygen (www.doxygen.org) for a project |
| # |
# |
|
|
| # The PROJECT_NAME tag is a single word (or a sequence of words surrounded |
# The PROJECT_NAME tag is a single word (or a sequence of words surrounded |
| # by quotes) that should identify the project. |
# by quotes) that should identify the project. |
| |
|
| PROJECT_NAME = libcfg # RAJO: @NAME@ |
PROJECT_NAME = libcfg |
| |
|
| # The PROJECT_NUMBER tag can be used to enter a project or revision number. |
# The PROJECT_NUMBER tag can be used to enter a project or revision number. |
| # This could be handy for archiving the generated documentation or |
# This could be handy for archiving the generated documentation or |
| # if some version control system is used. |
# if some version control system is used. |
| |
|
| PROJECT_NUMBER = 0.1 # RAJO: @VERSION@ |
PROJECT_NUMBER = 0.1 |
| |
|
| # The OUTPUT_DIRECTORY tag is used to specify the (relative or absolute) |
# The OUTPUT_DIRECTORY tag is used to specify the (relative or absolute) |
| # base path where the generated documentation will be put. |
# base path where the generated documentation will be put. |